Cena s DPH / bez DPH
Hlavní stránka>ASTM D4623-16 - Standard Test Method for Determination of In Situ Stress in Rock Mass by Overcoring Method—Three Component Borehole Deformation Gauge
Sponsored link
Vydáno: 01.12.2016

ASTM D4623-16 - Standard Test Method for Determination of In Situ Stress in Rock Mass by Overcoring Method—Three Component Borehole Deformation Gauge

Standard Test Method for Determination of In Situ Stress in Rock Mass by Overcoring Method—Three Component Borehole Deformation Gauge

Formát
Dostupnost
Cena a měna
Anglicky PDF
K okamžitému stažení
1404 Kč
Anglicky PDF Redline
K okamžitému stažení
1685 Kč
Anglicky Tisk
Skladem
1404 Kč
Označení normy:D4623-16
Vydáno:01.12.2016
Status:Active
Počet stran:16
Sekce:04.08
Označení:borehole; core; deformation; drilling; gauge; in situ; measurements; moduli; overcoring; rock; stress ; USBM gauge;
Popis

1.1 This test method covers the determination of the ambient local stresses (principal and secondary) in a rock mass and the equipment required to perform in situ stress tests using a three-component borehole deformation gauge (BDG) that was developed by the U.S. Bureau of Mines (USBM); see Note 1.

1.2 The test procedure and method of data reduction are described, including the theoretical basis and assumptions involved in the calculations.

1.3 A section is included on troubleshooting equipment malfunctions.

Note 1: The gauge used in this test method is commonly referred to by users as a USBM gauge (U.S. Bureau of Mines three-component borehole deformation gauge).2

1.4 The values stated in inch-pound units are to be regarded as standard, except as noted below. The values given in parentheses are mathematical conversions to SI units, which are provided for information only and are not considered standard. Reporting of test results in units other than SI shall not be regarded as nonconformance with this test method.

1.5 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.