ASTM D6423-20A - Standard Test Method for Determination of pHe of Denatured Fuel Ethanol and Ethanol Fuel Blends
Standard Test Method for Determination of pHe of Denatured Fuel Ethanol and Ethanol Fuel Blends
| Označení normy: | D6423-20A |
| Vydáno: | 01.07.2020 |
| Status: | Active |
| Počet stran: | 5 |
| Sekce: | 05.02 |
| Označení: | automotive spark ignition engine fuel; corrosion potential; denatured fuel ethanol; ethanol; ethanol fuel blends; ethanol-hydrocarbon blends; fuel ethanol; hydrogen ion activity; pHe; |
1.1 This test method covers a procedure to determine a measure of the hydrogen ion activity of high ethanol content fuels. These include denatured fuel ethanol and ethanol fuel blends. The test method is applicable to denatured fuel ethanol and ethanol fuel blends containing ethanol at 51 % by volume, or more.
1.2 Hydrogen ion activity as measured in this test method is defined as pHe. A pHe value for alcohol solutions is not comparable to pH values of water solutions.
1.2.1 The value of pHe measured will depend somewhat on the fuel blend, the stirring rate, and the time the electrode is in the fuel.
1.3 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.3.1 Hydrogen ion activity in water is expressed as pH and hydrogen ion activity in ethanol is expressed as pHe.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.