Cena s DPH / bez DPH
Hlavní stránka>ASTM D7611_D7611M-21 - Standard Practice for Coding Plastic Manufactured Articles for Resin Identification
Sponsored link
Vydáno: 01.12.2021

ASTM D7611_D7611M-21 - Standard Practice for Coding Plastic Manufactured Articles for Resin Identification

Standard Practice for Coding Plastic Manufactured Articles for Resin Identification

Formát
Dostupnost
Cena a měna
Anglicky PDF
K okamžitému stažení
1124 Kč
Anglicky PDF Redline
K okamžitému stažení
1311 Kč
Anglicky Tisk
Skladem
1124 Kč
Označení normy:D7611_D7611M-21
Vydáno:01.12.2021
Status:Active
Počet stran:4
Sekce:08.03
Označení:plastics; Resin Identification Code;
Popis

1.1 This practice stipulates the types, names, and sizes of Codes for those material types specified in Table 1.

1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system are likely not to be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems is likely to result in non-conformance with the standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

Note 1: There is no known ISO equivalent to this standard.

1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.