ASTM A0705_A0705M-23
Standard Specification for Age-Hardening Stainless Steel Forgings
| Označení normy: | ASTM A0705_A0705M-23 |
| Vydáno: | 01.05.2023 |
| Status: | Active |
| Počet stran: | 8 |
| Sekce: | 01.03 |
| Označení: | age-hardening stainless steel; precipitation hardening stainless steel; stainless steel forgings; |
| ASTM označení: | ASTM A705/A705M |
| Nahrazuje: | A0705_A0705M-22 |
This specification covers age-hardening stainless steel forgings for general use. Materials for forgings shall consist of billets or bars and shall either be forged, rolled, or cast or a section cut from an ingot. The steel specimens shall be solution annealed and age hardened and shall conform to the required values of tensile strength, yield strength, elongation, reduction of area, hardness and impact Charpy-V. The steel materials shall conform to the required chemical compositions of carbon, manganese, phosphorus, sulfur, silicon, chromium, nickel, aluminum, molybdenum, titanium, copper, nitrogen, columbium, and tantalum.
1.1 This specification2 covers age-hardening stainless steel forgings for general use.
1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system are not necessarily exact equivalents; therefore, to ensure conformance with the standard, each system shall be used independently of the other, and values from the two systems shall not be combined.
1.3 Unless the order specifies an “M” designation, the material shall be furnished to inch-pound units.
Note 1: Bar products are covered by Specification A564/A564M.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.