ASTM A0905-19
Standard Specification for Steel Wire, Pressure Vessel Winding
| Označení normy: | ASTM A0905-19 |
| Vydáno: | 01.09.2019 |
| Status: | Active |
| Počet stran: | 3 |
| Sekce: | 01.03 |
| Označení: | pressure vessel; winding; wire; |
| ASTM označení: | ASTM A905 |
| Nahrazuje: | A0905-04R17 |
This specification covers high strength, cold drawn or cold rolled steel wire with rectangular cross-section and round mill edge. The wire is intended for use in pre-stressed vessel and press frame windings. The steel shall be manufactured by basic oxygen, electric furnace, or vacuum induction processes and produced as ingot cast or continuous cast. Materials shall be tested for contents of carbon, manganese, phosphorus, sulphur, and silicon. A tension tests shall also be performed to evaluate mechanical properties conformance. Guidelines for workmanship, finish, and appearance are stated, as well as the inspection, certification of reports, packaging, marking, and loading for shipment.
1.1 This specification covers requirements for a high strength drawn and cold rolled steel wire in two strength classes, with rectangular cross section, and round mill edge. This wire is intended for prestressed vessel and press frame windings.
1.2 The values stated in either inch-pound units or SI (metric) units are to be regarded separately as standards. Within the text and tables, the SI units are shown in parentheses. The values stated in each system are not exact equivalents. Therefore, each system must be used independent of the other. Combining values from the two systems may result in nonconformance with the specification.
1.3 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.