ASTM A1011_A1011M-25
Standard Specification for Steel, Sheet and Strip, Hot-Rolled, Carbon, Structural, High-Strength Low-Alloy, High-Strength Low-Alloy with Improved Formability, and Ultra-High-Strength
| Označení normy: | ASTM A1011_A1011M-25 |
| Vydáno: | 01.12.2025 |
| Status: | Active |
| Počet stran: | 8 |
| Sekce: | 01.03 |
| Označení: | carbon steel sheet; carbon steel strip; commercial steel; drawing steel; special forming steel; high strength-low alloy steel; high strength-low alloy steel with improved formability; hot-rolled steel sheet; hot-rolled steel strip; steel sheet; steel strip; structural steel; ultra-high-strength steel; |
| ASTM označení: | ASTM A1011/A1011M |
| Nahrazuje: | A1011_A1011M-23 |
1.1 This specification covers hot-rolled, carbon, structural, high-strength low-alloy, high-strength low-alloy with improved formability, and ultra-high-strength steel sheet and strip, in coils and cut lengths.
1.2 Hot rolled steel sheet and strip is available in the designations as listed in 4.1.
1.3 This specification is not applicable to the steel covered by Specification A635/A635M.
1.4 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.