ASTM A1014_A1014M-16R21
Standard Specification for Precipitation-Hardening Bolting (UNS N07718) for High Temperature Service
| Označení normy: | ASTM A1014_A1014M-16R21 |
| Vydáno: | 01.09.2021 |
| Status: | Active |
| Počet stran: | 4 |
| Sekce: | 01.01 |
| Označení: | bolting; bolting materials; bolting components; Inconel 718; nickel alloy; precipitation hardening; temperature service application – high; |
| ASTM označení: | ASTM A1014/A1014M |
| Nahrazuje: | A1014_A1014M-16E01 |
1.1 This specification covers precipitation hardening bolting material (UNS N07718) and bolting components for high temperature service. See Specification A962/A962M for the definition of “bolting.”
1.2 The following referenced general requirements are indispensable for application of this specification: Specification A962/A962M.
1.3 Supplementary requirements are provided for use at the option of the purchaser. The supplementary requirements only apply when specified individually in the purchase order or contract.
1.4 This specification is expressed in both inch-pound and in SI units. However, unless the purchase order or contract specifies the applicable M designation (SI units), the inch-pound units shall apply.
1.5 The values stated in either SI units or inch-pound units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.