ASTM B0100-20
Standard Specification for Wrought Copper-Alloy Bearing and Expansion Plates and Sheets for Bridge and Other Structural Use
| Označení normy: | ASTM B0100-20 |
| Vydáno: | 01.04.2020 |
| Status: | Active |
| Počet stran: | 5 |
| Sekce: | 02.01 |
| Označení: | bearing plates; bearing sheets; bridges; copper-alloy plates; copper-alloy sheets; expansion bearing plates; expansion bearing sheets; structures; UNS No. C51000; UNS No. C51100; UNS No. C61300; UNS No. C61400; UNS No. C65500; |
| ASTM označení: | ASTM B100 |
| Nahrazuje: | B0100-13 |
1.1 This specification establishes the requirements for wrought copper-alloy bearing plate and bearing sheets for application in bridges and other structures. Specifically, the plates and sheets are to be used for fixed or expansion bearings where the motion is slow and intermittent with pressures not exceeding 3 ksi (20 MPa).
1.2 Units—The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
1.2.1 Exception—Values given in inch-pound units are the standard except for grain size, which is stated in SI units.
1.3 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.