ASTM B0636_B0636M-15R21
Standard Test Method for Measurement of Internal Stress of Plated Metallic Coatings with the Spiral Contractometer
| Označení normy: | ASTM B0636_B0636M-15R21 |
| Vydáno: | 01.10.2021 |
| Status: | Active |
| Počet stran: | 5 |
| Sekce: | 02.05 |
| Označení: | internal deposit stress test; metallic deposit ; |
| ASTM označení: | ASTM B636/B636M |
| Nahrazuje: | B0636_B0636M-15 |
1.1 This test method covers the use of the spiral contractometer for measuring the internal stress of metallic coatings as produced from plating solutions on a helical cathode. The test method can be used with electrolytic and autocatalytic deposits.
1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.