ASTM C1587_C1587M-21A
Standard Practice for Preparation of Field Removed Manufactured Masonry Units and Masonry Specimens for Testing
| Označení normy: | ASTM C1587_C1587M-21A |
| Vydáno: | 01.06.2021 |
| Status: | Active |
| Počet stran: | 3 |
| Sekce: | 04.05 |
| Označení: | bond wrench; brick; compressive strength testing; concrete masonry unit; flexural bond strength testing; grout; hardened mortar; manufactured masonry units; masonry prisms; masonry specimens; mortar; preparation of masonry for testing; structural clay tile; |
| ASTM označení: | ASTM C1587/C1587M |
| Nahrazuje: | C1587_C1587M-21 |
1.1 The purpose of this practice is to standardize the preparation of manufactured masonry units and masonry specimens extracted from the field for compressive and flexural bond strength testing in a laboratory environment.
1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The inch-pound units are shown in brackets. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.