ASTM C1646_C1646M-24
Standard Practice for Making and Curing Test Specimens for Evaluating Resistance of Coarse Aggregate to Freezing and Thawing in Air-Entrained Concrete
| Označení normy: | ASTM C1646_C1646M-24 |
| Vydáno: | 15.12.2024 |
| Status: | Active |
| Počet stran: | 3 |
| Sekce: | 04.02 |
| Označení: | aggregate; coarse aggregate; freezing and thawing; |
| ASTM označení: | ASTM C1646/C1646M |
| Nahrazuje: | C1646_C1646M-16 |
1.1 This practice covers procedures for making and curing test specimens for evaluating resistance of normal-weight coarse aggregates to freezing and thawing in air-entrained concrete in accordance with Test Method C666/C666M, Procedure A or B.
1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system are not necessarily exact equivalents; therefore, to ensure conformance with the standard, each system shall be used independently of the other, and values from the two systems shall not be combined.
Note 1: Sieve size is identified by its standard designation in Specification E11. The alternative designation given in parenthesis is for information only and does not represent a different standard sieve size.
1.3 If results obtained from another standard are not reported in the same system of units as used by this standard, it is permitted to convert those results using the conversion factors found in the SI Quick Reference Guide.2
1.4 The text of this standard refers to notes and footnotes that provide explanatory material. These notes and footnotes (excluding those in tables and figures) shall not be considered as requirements of this standard.
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. (Warning—Fresh hydraulic cementitious mixtures are caustic and may cause chemical burns to skin and tissue upon prolonged exposure.3
)
1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.