ASTM D2143-21
Standard Test Method for Cyclic Pressure Strength of Reinforced, Thermosetting Plastic Pipe
| Označení normy: | ASTM D2143-21 |
| Vydáno: | 01.04.2021 |
| Status: | Active |
| Počet stran: | 4 |
| Sekce: | 08.03 |
| Označení: | cyclic pressure strength; fiberglass pipe; hydrostatic design basis; pressure design basis; |
| ASTM označení: | ASTM D2143 |
| Nahrazuje: | D2143-15 |
1.1 This test method covers the determination of the failure characteristics of reinforced plastic pipe when subjected to cyclic internal hydraulic pressure. It is limited to pipe in which the ratio of outside diameter to wall thickness is 10:1 or more.
1.2 The values stated in inch-pound units are to be regarded as the standard. The values in parentheses are for information only.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
Note 1: There is no known ISO equivalent to this standard.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.