ASTM D2319_D2319M-20
Standard Test Method for Softening Point of Pitch (Cube-in-Air Method)
| Označení normy: | ASTM D2319_D2319M-20 |
| Vydáno: | 01.06.2020 |
| Status: | Active |
| Počet stran: | 3 |
| Sekce: | 05.01 |
| Označení: | cube-in-air; pitch; softening point; |
| ASTM označení: | ASTM D2319/D2319M |
| Nahrazuje: | D2319_D2319M-14E01 |
1.1 This test method covers the determination of the softening point above 80 °C [176 °F] of pitch. Test Method D3104 gives comparable results.
1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.