ASTM D3314-02R25
Standard Test Method for Rubber—Chemical Analysis for Polystyrene Blocks In SBR (Styrene-Butadiene Rubber) and Styrene-Reinforced Latices
| Označení normy: | ASTM D3314-02R25 |
| Vydáno: | 01.09.2025 |
| Status: | Active |
| Počet stran: | 4 |
| Sekce: | 09.01 |
| Označení: | polystyrene; SBR; styrene-butadiene rubber; |
| ASTM označení: | ASTM D3314 |
| Nahrazuje: | D3314-02R21 |
1.1 This test method covers the determination of long polystyrene blocks in SBR rubbers and styrene-reinforced latices.
1.2 Percent block styrene content may be determined in the range from 1 to 100 %.
1.3 This test method is intended for use on gel-free polymers, but it may be used on polymers containing gel, if it has been proven that gel does not interfere.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. For specific hazard statements, see Section 7.
1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.