ASTM D3412_D3412M-13R20
Standard Test Method for Coefficient of Friction, Yarn to Yarn
| Označení normy: | ASTM D3412_D3412M-13R20 |
| Vydáno: | 01.02.2020 |
| Status: | Active |
| Počet stran: | 6 |
| Sekce: | 07.01 |
| Označení: | coefficient of friction; yarns; yarn to yarn; |
| ASTM označení: | ASTM D3412/D3412M |
| Nahrazuje: | D3412_D3412M-13 |
1.1 This test method covers the measurement of frictional properties for both continuous filament and spun-staple yarns under boundary friction conditions.
1.2 This test method has been used with yarns having linear densities ranging from 1.5 to 400 tex, but may be used with yarns outside these ranges [15 to 3600 denier].
Note 1: For coefficient of friction, yarn to metal, see Test Method D3108/D3108M.
1.3 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system are not necessarily exact equivalents; therefore, to ensure conformance with the standard, each system shall be used independently of the other, and values from the two systems shall not be combined.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.