ASTM D3767-03R20
Standard Practice for Rubber—Measurement of Dimensions
| Označení normy: | ASTM D3767-03R20 |
| Vydáno: | 01.02.2020 |
| Status: | Active |
| Počet stran: | 8 |
| Sekce: | 09.01 |
| Označení: | dimensions; measurement ; |
| ASTM označení: | ASTM D3767 |
| Nahrazuje: | D3767-03R14 |
1.1 This practice is intended for use in determining the geometrical dimensions of rubber products and specimens for physical tests. This practice describes procedures for determining length, width, thickness, diameter, and circumference. This practice does not cover sampling of materials or products, or locations where a sample is to be taken.
1.2 The values stated in either acceptable metric units or in other units shall be regarded separately as a standard. The values stated in each system may not be exact equivalents; therefore, each system must be used independently of the other, without combining values in any other way.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.