ASTM D3776_D3776M-20R25
Standard Test Methods for Mass Per Unit Area (Weight) of Fabric
| Označení normy: | ASTM D3776_D3776M-20R25 |
| Vydáno: | 01.06.2025 |
| Status: | Active |
| Počet stran: | 5 |
| Sekce: | 07.01 |
| Označení: | fabric; mass per unit area; weight ; |
| ASTM označení: | ASTM D3776/D3776M |
| Nahrazuje: | D3776_D3776M-20 |
1.1 These test methods cover the measurement of fabric mass per unit area (traditionally referred to as “fabric weight”) and are applicable to most fabrics.
1.2 There are four approved options:
1.2.1 Option A—Full Piece, Roll, Bolt or Cut (Section 7).
1.2.2 Option B—Full Width Sample (Section 8).
1.2.3 Option C—Small Swatch of Fabric (Section 9).
1.2.4 Option D—Narrow Fabrics (Section 10).
1.3 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system are not necessarily exact equivalents; therefore, to ensure conformance with the standard, each system shall be used independently of the other, and values from the two systems shall not be combined.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.