ASTM D4761-25
Standard Test Methods for Mechanical Properties of Lumber and Wood-Based Structural Materials
| Označení normy: | ASTM D4761-25 |
| Vydáno: | 15.10.2025 |
| Status: | Active |
| Počet stran: | 12 |
| Sekce: | 04.10 |
| Označení: | lumber; mechanical properties; wood-base; |
| ASTM označení: | ASTM D4761 |
| Nahrazuje: | D4761-19 |
1.1 These test methods cover the determination of the mechanical properties of stress-graded lumber and other wood-based structural materials.
1.2 These test methods appear in the following order:
|
| Section |
| Bending edge-wise | 6 |
| Bending flat-wise: |
|
| Center-point loading | 7 |
| Third-point loading | 8 |
| Axial strength in tension | 9 |
| Axial strength in compression | 10 |
1.3 Units—The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.