ASTM D7919-14R21

1.1 This guide pertains to removal and analysis techniques to extract debris captured by in-service lubricant and hydraulic filters and to analyze the debris removed.

1.2 This guide suggests techniques to remove, collect and analyze debris from filters in support of machinery health condition monitoring.

1.3 Debris removal techniques range from manual to automated.

1.4 Analysis techniques vary from visual, particle counting, microscopic, x-ray fluorescence (XRF), atomic emission spectroscopy (AES), and scanning electron microscopy energy dispersive x-rays (SEMEDX).

1.5 This guide is suitable for use with the following filter types: screw on, metal mesh, and removable diagnostic layer filters.

1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.7 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.