ASTM D7920-21
Standard Test Method for Determination of Fuel Methanol (M99) and Methanol Fuel Blends (M10 to M99) by Gas Chromatography
| Označení normy: | ASTM D7920-21 |
| Vydáno: | 01.01.2021 |
| Status: | Active |
| Počet stran: | 13 |
| Sekce: | 05.04 |
| Označení: | fuel methanol; impurities in methanol; methanol content in gasoline; methanol fuel; methanol-gasoline blends; |
| ASTM označení: | ASTM D7920 |
| Nahrazuje: | D7920-15E01 |
1.1 This test method covers the determination of the methanol content, by gas chromatography, of M10 to M99 in methanol fuel blends, including fuel methanol (M99).
1.1.1 Methanol may be determined from 10 % to 99 % by volume.
1.2 This test method is designed to measure not only methanol in the blended gasoline but also the impurities in fuel methanol (M99) itself in the range of 5 mg/kg to 1000 mg/kg. However, not all impurities are measured nor detected by this test method.
1.2.1 Water cannot be determined by this test method and shall be measured by a procedure such as Test Method D1364 and the result used to correct the concentrations determined by this test method.
1.3 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.