ASTM D8337_D8337M-21

1.1 This test method describes the apparatus and procedure to evaluate the lap shear bond properties of wet lay-up or shop-fabricated (for example, pultruded) fiber-reinforced polymer (FRP) composite systems adhesively applied to a flat concrete substrate. The test determines the plateau force that an FRP system can bear before complete debonding from a concrete prism tested using a direct single-lap shear test. This plateau force is reported as bond capacity and may be different from the maximum applied force. The plateau force is then used to determine the interfacial fracture energy and the cohesive material law.

1.2 This test method is not intended for job approval or for product qualification purposes unless an external agency adopts the test method for those purposes.

1.3 This test method is intended for use with adhesive-applied or wet lay-up FRP systems and is appropriate for use with FRP systems having any fiber orientation or combination of ply orientations comprising the FRP composite, although the test condition only considers forces in the direction parallel to the prism longitudinal axis.

1.4 Units—The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system are not necessarily exact equivalents; therefore, to ensure conformance with the standard, each system shall be used independently of the other, and values from the two systems shall not be combined.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.