ASTM E1078-14R20
Standard Guide for Specimen Preparation and Mounting in Surface Analysis
| Označení normy: | ASTM E1078-14R20 |
| Vydáno: | 01.12.2020 |
| Status: | Active |
| Počet stran: | 10 |
| Sekce: | 03.06 |
| Označení: | Auger electron spectroscopy; secondary ion mass spectroscopy; specimen mounting; specimen preparation; specimen treatment; surface analysis; X-ray photoelectron spectroscopy; |
| ASTM označení: | ASTM E1078 |
| Nahrazuje: | E1078-14 |
1.1 This guide covers specimen preparation and mounting prior to, during, and following surface analysis and applies to the following surface analysis disciplines:
1.1.1 Auger electron spectroscopy (AES),
1.1.2 X-ray photoelectron spectroscopy (XPS and ESCA), and
1.1.3 Secondary ion mass spectrometry (SIMS).
1.1.4 Although primarily written for AES, XPS, and SIMS, these methods will also apply to many surface sensitive analysis methods, such as ion scattering spectrometry, low energy electron diffraction, and electron energy loss spectroscopy, where specimen handling can influence surface sensitive measurements.
1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.