ASTM E1155_E1155M-23
Standard Test Method for Determining <emph type="ital">F<inf>F</inf></emph> Floor Flatness and <emph type="ital">F<inf>L</inf></emph> Floor Levelness Numbers
| Označení normy: | ASTM E1155_E1155M-23 |
| Vydáno: | 15.01.2023 |
| Status: | Active |
| Počet stran: | 9 |
| Sekce: | 04.11 |
| Označení: | Ff; FF Flatness; Fl; FL Levelness; floor; floor profile; floor profilometer; F-Number; |
| ASTM označení: | ASTM E1155/E1155M |
| Nahrazuje: | E1155-20 |
1.1 This test method covers a quantitative method of measuring floor surface profiles to obtain estimates of the floor’s characteristic FF Flatness and FL Levelness Face Floor Profile Numbers (F-Numbers).
1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system are not necessarily exact equivalents; therefore, to ensure conformance with the standard, each system shall be used independently of the other, and values from the two systems shall not be combined.
1.3 The text of this test method references notes and footnotes that provide explanatory material. These notes and footnotes (excluding those in tables and figures) shall not be considered as requirements of this test method.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.