ASTM E1634-11R19
Standard Guide for Performing Sputter Crater Depth Measurements
| Označení normy: | ASTM E1634-11R19 |
| Vydáno: | 01.11.2019 |
| Status: | Active |
| Počet stran: | 3 |
| Sekce: | 03.06 |
| Označení: | Auger electron spectroscopy; secondary ion mass spectrometry; stylus profilometry; surface analysis ; X-ray photoelectron spectroscopy; |
| ASTM označení: | ASTM E1634 |
| Nahrazuje: | E1634-11 |
1.1 This guide covers the preferred procedure for acquiring and post-processing of sputter crater depth measurements. This guide is limited to stylus-type surface profilometers equipped with a stage, stylus, associated scan and sensing electronics, video system for sample and scan alignment, and computerized system.
1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.