ASTM E2109-01R21
Standard Test Methods for Determining Area Percentage Porosity in Thermal Sprayed Coatings
| Označení normy: | ASTM E2109-01R21 |
| Vydáno: | 01.09.2021 |
| Status: | Active |
| Počet stran: | 8 |
| Sekce: | 03.01 |
| Označení: | area fraction; automatic image analysis; porosity; TSCs; |
| ASTM označení: | ASTM E2109 |
| Nahrazuje: | E2109-01R14 |
1.1 These test methods cover procedures to perform porosity ratings on metallographic specimens of thermal sprayed coatings (TSCs) prepared in accordance with Guide E1920 by direct comparison to standard images and via the use of automatic image analysis equipment.
1.2 These test methods deal only with recommended measuring methods and nothing in them should be construed as defining or establishing limits of acceptability for any measured value of porosity.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.