ASTM E2113-23
Standard Test Method for Length Change Calibration of Thermomechanical Analyzers
| Označení normy: | ASTM E2113-23 |
| Vydáno: | 01.08.2023 |
| Status: | Active |
| Počet stran: | 5 |
| Sekce: | 14.01 |
| Označení: | calibration; coefficient of thermal expansion; deflection; expansion; expansivity; thermal analysis; thermal expansion; thermomechanical analyzer (TMA); |
| ASTM označení: | ASTM E2113 |
| Nahrazuje: | E2113-18 |
1.1 This test method describes calibration of the length change (deflection) measurement or thermal expansion of thermomechanical analyzers (TMAs) within the temperature range from –150 °C to 1000 °C using the thermal expansion of a suitable reference material.
1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.