ASTM F0468M-06R25
Standard Specification for Nonferrous Bolts, Hex Cap Screws, and Studs for General Use (Metric)
| Označení normy: | ASTM F0468M-06R25 |
| Vydáno: | 01.12.2025 |
| Status: | Active |
| Počet stran: | 10 |
| Sekce: | 01.09 |
| Označení: | bolts; cap screws; general use; nonferrous; studs ; |
| ASTM označení: | ASTM F468M |
| Nahrazuje: | F0468M-06R18 |
1.1 This specification covers the requirements for commercial wrought nonferrous bolts, hex cap screws, and studs in nominal thread diameters M6 to M36 inclusive manufactured from a number of alloys in common use and intended for general service applications.
1.2 Unless otherwise specified, nuts used on these bolts, cap screws, and studs shall conform to the requirements of Specification F467M. Nuts shall be of the same alloy group as the fastener on which they are used and shall have a specified minimum proof stress equal to or greater than the specified minimum tensile strength stress of the fastener on which they are used.
1.3 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
Note 1: This specification is the metric companion of Specification F468.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.