ASTM F1973-25
Standard Specification for Factory Assembled Anodeless Risers and Transition Fittings in Polyethylene (PE) and Polyamide 11 (PA11) and Polyamide 12 (PA12) Fuel Gas Distribution Systems
| Označení normy: | ASTM F1973-25 |
| Vydáno: | 01.05.2025 |
| Status: | Active |
| Počet stran: | 5 |
| Sekce: | 08.04 |
| Označení: | anodeless risers; fuel gas piping; plastic gas piping; plastic pipe; polyamide 11; polyamide 12; pressure pipe; risers; transitions; |
| ASTM označení: | ASTM F1973 |
| Nahrazuje: | F1973-21 |
1.1 This specification covers requirements and test methods for the qualification of factory assembled anodeless risers and transition fittings, for use in polyethylene (PE), in sizes through NPS 16, and Polyamide 11 (PA11) and Polyamide 12 (PA12), in sizes through NPS 6, gas distribution systems.
1.2 The test methods described are not intended to be routine quality control tests.
1.3 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
1.4 Throughout this specification footnotes are provided for informational purposes and shall not be considered as requirements of this specification.
1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.