ASTM F2092-24
Standard Specification for Convection Oven Gas or Electric
| Označení normy: | ASTM F2092-24 |
| Vydáno: | 01.02.2024 |
| Status: | Active |
| Počet stran: | 6 |
| Sekce: | 15.12 |
| Označení: | baking oven; convection oven; cooking device; extended cavity oven; food service equipment; rethermalizing oven; roasting oven; roll-in oven; |
| ASTM označení: | ASTM F2092 |
| Nahrazuje: | F2092-14R22 |
This specification covers forced air convection ovens for baking, roasting or rethermalizing which utilize gas or electrical heat sources, or both for cooking food in the commercial and institutional food service establishments. Convection ovens covered by this specification are classified by type, grade, class, size, style and capacity: Type I, Type II, and Type III; Grade A and Grade B; Class 1, Class 2, Class 3, Class 4, Class 5, Class 6, Class 7, Class 8, Class 9, Class 10, and Class 11; Size a and Size b; and Style i and Style ii. Performance testing and thermostat test shall be performed to conform with the specified requirements.
1.1 This specification covers forced air convection ovens for baking, roasting or rethermalizing which utilize gas or electrical heat sources, or both for cooking food in the commercial and institutional food service establishments. The units may have water and drain connections for adding moisture but do not have a dedicated steam only mode.
1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
1.3 This standard may involve hazardous materials, operations, and equipment. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.