ASTM F2774-24

1.1 This practice covers the manufacturing quality control of Consumer Trampoline-Bed Material (CTM), describing types of tests, the proper test methods, minimum testing frequencies, and best practices for sampling.

1.2 This practice is intended to aid manufacturers, suppliers, purchasers, installers, and end users of CTM in establishing a minimum level of effort for maintaining quality control.

1.3 This practice does not address manufacturing quality assurance, product acceptance testing, or conformance testing. These are independent activities taken by organizations other than the CTM manufacturer.

1.4 This practice covers procedures for sampling CTM for the purpose of manufacturing quality control (MQC). These procedures are designed to ensure the correct number of representative samples are obtained and properly reported by the manufacturer.

1.5 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.

1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.7 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.