BS EN 1555-1:2025 - TC

This standard BS EN 1555-1:2025 - TC Tracked Changes. Plastics piping systems for the supply of gaseous fuels. Polyethylene (PE) is classified in these ICS categories:

• 91.140.40 Gas supply systems
• 01.040.23 Fluid systems and components for general use (Vocabularies)
• 01.040.91 Construction materials and building (Vocabularies)
• 23.040.01 Pipeline components and pipelines in general

This document specifies materials and the general aspects of polyethylene (PE) piping systems in the field of the supply of gaseous fuels. NOTE For the purpose of this document the term gaseous fuels include for example natural gas, methane, butane, propane, hydrogen, manufactured gas, biogas, and mixtures of these gases. It also specifies the test parameters for the test methods referred to in this document. In conjunction with EN 1555-2, EN 1555-3, EN 1555-4 and EN 1555-5, this document is applicable to PE pipes, fittings and valves, their joints and, joints with components of PE and other materials intended to be used under the following conditions: a) a maximum operating pressure, MOP, up to and including 10 bar at a design reference temperature of 20 °C; b) an operating temperature between −20 °C and 40 °C. For operating temperatures between 20 °C and 40 °C, derating coefficients are specified in EN 1555-5. The EN 1555 series covers a range of MOPs and gives requirements concerning colours. It is the responsibility of the purchaser or specifier to make the appropriate selections from these aspects, taking into account their particular requirements and any relevant national guidance or regulations and installation practices or codes.