ASTM D3363-22
Standard Test Method for Film Hardness by Pencil Test
| Označení normy: | ASTM D3363-22 |
| Vydáno: | 01.06.2022 |
| Status: | Active |
| Počet stran: | 4 |
| Sekce: | 06.01 |
| Označení: | hardness (scratch); pencil hardness; |
| ASTM označení: | ASTM D3363 |
| Nahrazuje: | D3363-20 |
1.1 This test method covers a procedure for rapid, inexpensive determination of the film hardness of an organic coating on a metal or similarly hard substrate in terms of drawing leads or pencil leads of known hardness.
1.2 This test method is similar in content (but not technically equivalent) to ISO 15184.
Note 1: Other procedures are available to measure permanent deformation of organic coatings under the action of a single point (stylus tip) including but not limited to Test Methods D2197, D5178, and G171.
1.3 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.