ASTM E2730-22
Standard Guide for Calibration and Use of Thermocouple Reference Junction Probes in Evaluation of Electronic Reference Junction Compensation Circuits
| Označení normy: | ASTM E2730-22 |
| Vydáno: | 01.05.2022 |
| Status: | Active |
| Počet stran: | 8 |
| Sekce: | 14.03 |
| Označení: | calibration; PRT; reference junction compensation; reference junction probe; Seebeck coefficient; SPRT; thermocouple; verification; |
| ASTM označení: | ASTM E2730 |
| Nahrazuje: | E2730-21 |
1.1 This guide covers methods of calibration and use of thermocouple reference junction probes (cold junction compensation probes) in the evaluation of electronic reference junction compensation circuits. Their use with instruments that measure only voltage is also covered.
1.2 The values stated in SI units are to be regarded as standard. The values given in parentheses after SI units are provided for information only and are not considered standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.