This document specifies a method for measuring the combined effects of heat and air on a thin moving film of bitumen or bituminous binder simulating the hardening which most bituminous binders undergo during mixing in an asphalt mixing plant. The method described is not applicable to some modified binders or to those where the viscosity does not allow to provide a moving film. In some cases, the sample may creep out of the glass container and flow on the heating elements of the oven during testing. The method is suitable for other bituminous binders than paving grade bitumen, but the reference temperature might give excessive hardening that do not resemble real conditions during mixing at the plant. The method may not represent the hardening that occurs during mixing of warm mix binders. The method is referred to as RTFOT, i.e. Rolling Thin Film Oven Test. WARNING Use of this document can involve hazardous materials, operations and equipment. This document does not purport to address all of the safety problems associated with its use. It is the responsibility of the user of this document to identify the hazards and assess the risks involved in performing this test method and to implement sufficient control measures to protect individual operators (and the environment). This includes appropriate safety and health practices and determination of the applicability of regulatory limitations prior to use. If there is a likelihood of volatile components being present in a binder, this procedure should not be used. It should not be used for cutback bitumen or bituminous emulsions before these products have been stabilized, e.g. in accordance with EN 13074-2.