This European Standard describes all significant hazards, hazardous situations and events relating to plating and anodizing lines, when used as intended and in compliance with the foreseeable conditions of the manufacturer. In addition, procedures for testing and measuring safety requirements, marking of equipment and minimum operation requirements are be specified. For reference to plating lines and anodizing lines the term machinery is used in this standard. This standard applies to the design and construction of plating lines and anodizing lines including its transport systems for surface treatment of industrial products by means of inorganic or organic electrolytes or by means of other process chemistries. Plating lines and anodizing lines in terms of this standard are arrangements of process tanks for electrolytic treatment of work pieces (e.g. electrocleaning, passivation, electroetching, burnishing, electrolytic polishing and brightening, drying); wet chemical treatment of work pieces (e.g. degreasing, passivation, chemical polishing, etching, pickling, blackening); electrolytic and electro-less metal deposition, even on non-metallic work pieces made electrically conductive by corresponding treatment; changing of substance composition on the surface of metallic work pieces e.g. burnishing, blackening, phosphatizing, chromating and; anodizing (anodic oxidation); including rinsing tanks and the corresponding transporter equipment (hoists), where the products are lifted in and out of tanks. This standard distinguishes between the following types of plating lines: Type 1: manual plating lines Type 2: semi-automatic lines Type 3: fully automatic lines Furthermore, it specifies equipment marking and requirements on user information. This standard does not deal with hazards resulting from machinery parts above category 1 of PED. This standard is not applicable to: transport systems of carrousel lines; equipment for the preparation and treatment of water and wastewater; machinery for dip coating and electro-deposition of organic liquid coating material (EN 12581); horizontal plating lines (e.g. printed circuit board, etching, reel to reel, continuous plating lines); machinery for surface cleaning and surface pre-treatment of industrial items using liquids or vapours (EN 12921-1, EN 12921-2, EN 12921-3, EN 12921-4). NOTE Machinery for surface cleaning and surface per-treatment (EN 12921 series) could be part of a plating line.