F2203-13R18
Standard Test Method for Linear Measurement Using Precision Steel Rule
| Označení normy: | F2203-13R18 |
| Vydáno: | 01.09.2018 |
| Status: | Active |
| Počet stran: | 3 |
| Sekce: | 15.10 |
| Označení: | dimension; linear measurement; rule; scale; |
1.1 This test method covers the measurement of linear dimension of flexible packages and packaging materials. It is recommended for use with an allowable tolerance range of 3 mm (1/8 in.) or greater based on gage repeatability and reproducibility presented in the Precision and Bias section.
1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
1.3 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.