D2394-17R22 - Standard Test Methods for Simulated Service Testing of Wood and Wood-Based Finish Flooring
Standard Test Methods for Simulated Service Testing of Wood and Wood-Based Finish Flooring
| Označení normy: | D2394-17R22 |
| Vydáno: | 01.08.2022 |
| Status: | Active |
| Počet stran: | 11 |
| Sekce: | 04.10 |
| Označení: | flooring; wood; wood-based; wood-based finish flooring; |
1.1 These test methods cover procedures for measuring the performance of finish flooring under the following service loadings and conditions:
|
| Section |
| Loading Tests |
|
| Concentrated Loading | 7 |
| Floor Surface Indentation from Small Area Loads | 12 |
| Falling-Ball Indentation | 18 |
| Rolling Load | 23 |
| Mechanical Tests |
|
| Abrasion Resistance | 28 |
| Coefficient of Friction | 33 |
| Moisture Tests |
|
| Surface Wetting | 38 |
1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.