ASTM F1150-22
Standard Specification for Commercial Food Waste Pulper and Waterpress Assembly
| Označení normy: | ASTM F1150-22 |
| Vydáno: | 01.04.2022 |
| Status: | Active |
| Počet stran: | 5 |
| Sekce: | 15.12 |
| Označení: | food waste pulper; pulper; waterpress; |
| ASTM označení: | ASTM F1150 |
| Nahrazuje: | F1150-16 |
This specification establishes the material, design, and performance requirements pertinent to the construction of commercial pulping and waterpress assemblies that are intended for grinding food scraps, paper, cardboard, and disposable plastic food-service ware. Unless otherwise specified, materials used to fabricate pulpers and waterpresses may include corrosion-resistant steel and other corrosion-resisting materials, abrasion-resistant cast iron, austenitic gray iron, copper tube, brass pipe, alloy steel, black and galvanized pipe, gaskets and seals, perforated metal, stainless steel pipe, plastic piping and fitting, and austenitic gray iron pipe fitting. Assembled pulpers and waterpresses shall meet operational, electrical, lubrication, finish, and performance requirements, and should function satisfactorily as specified.
1.1 This specification covers commercial pulping and waterpress assemblies intended for grinding of food scraps, paper, cardboard, and disposable plastic food-service ware.
1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
1.3 The following safety hazards caveat pertains only to the test method portion, Section 13, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.