Replace the title above Clause 1 Scope with the following: FIXED RESISTORS FOR USE IN ELECTRONIC EQUIPMENT Part 2-10xx: Detail specification: Low-power film resistors with leads for through-hole assembly on circuit boards (THT), & , for general electronic equipment, classification level G Add the following comment below the title: COMMENT The above title without the introductory word blank is to become the title of the intended detail specification, which is drafted on the basis of this blank detail specification. The actual title of the intended detail specification should hold some wording descriptive for the particular kind of components covered therein, where indicated by & , in order to support the differentiation between parallel detail specification on the same level. An example for such descriptive wording would be: stability classes 0,1; 0,25 .