This document specifies the methods of preparation of test specimens and the t est methods for determining the properties of polyethylene (PE) moulding and extrusion materials. It establishes general principles for handling test material and for conditioning both the test material before moulding and the specimens before testing. This document specifies the procedures and conditions for the preparation of test specimens and procedures for measuring properties of the materials from which these specimens are made. It gives guidance on properties and test methods that are suitable and essential to characterize PE materials for injection moulding and extrusion. The properties have been selected from the general test methods in ISO 10350-1. Other test methods in wide use for or of particular significance to these moulding and extrusion materials are also included in this document, as are the designatory properties specified in ISO 17855-1. In order to obtain reproducible and comparable test results, it give guidance on using the methods of preparation and conditioning, the specimen dimensions and the test procedures specified herein. Values determined will not necessarily be identical to those obtained using specimens of different dimensions or prepared using different procedures.