ASTM A0956_A0956M-22
Standard Test Method for Leeb Hardness Testing of Steel Products
| Označení normy: | ASTM A0956_A0956M-22 |
| Vydáno: | 01.09.2022 |
| Status: | Active |
| Počet stran: | 13 |
| Sekce: | 01.03 |
| Označení: | dynamic hardness test; Equotip; Equotip hardness test; Leeb; rebound hardness test; |
| ASTM označení: | ASTM A956/A956M |
| Nahrazuje: | A0956_A0956M-17A |
1.1 This test method covers the determination of the Leeb hardness of steel, cast steel, and cast iron (Part A), including the methods for the verification of Leeb hardness testing instruments (Part B), and the calibration of standardized test blocks (Part C).
Note 1: The original title of this standard was “Standard Test Method for Equotip Hardness Testing of Steel Products.”1
1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system are not necessarily exact equivalents; therefore, to ensure conformance with the standard, each system shall be used independently of the other, and values from the two systems shall not be combined.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.