ASTM C1529-19R25
Standard Specification for Quicklime, Hydrated Lime, and Limestone for Environmental Uses
| Označení normy: | ASTM C1529-19R25 |
| Vydáno: | 01.12.2025 |
| Status: | Active |
| Počet stran: | 2 |
| Sekce: | 04.01 |
| Označení: | biosolids; by-product lime; calcium oxide; dolomitic lime; dolomitic limestone; drinking water; environmental; high calcium lime; high calcium limestone; hydrated lime; industrial waste; lime; limestone; magnesian lime; magnesian limestone; neutralization; quicklime; residuals; sewage sludge; stabilization; treatment; waste; wastewater; water; water softening; |
| ASTM označení: | ASTM C1529 |
| Nahrazuje: | C1529-19 |
This specification covers lime and limestone productions and by-product alkaline materials suitable for environmental uses. Requirements for quicklime, hydrated lime, and limestone for the designated end uses are specified, and are on the basis of the weight of sample taken at the place of manufacture. Quicklime shall be free of unslakable residues and shall be capable of disintegrating in water to form a suspension of finely divided material. The amount of residue shall not exceed that agreed upon between the manufacturer and the purchaser (the residue is the amount of the material retained on a specified screen). The slaking rate for the specified quicklime should be matched to the requirements of the slaking equipment. Test methods such as chemical analyses, physical tests and basic factor test shall be performed.
1.1 This specification covers lime and limestone products and by-product alkaline materials suitable for environmental uses as shown in Table 1.
| CQ | = | Quicklime, high-calcium |
| DQ | = | Quicklime, dolomitic |
| MQ | = | Quicklime, magnesian |
| CH | = | Hydrated lime, high-calcium |
| DH | = | Hydrated lime, dolomitic |
| MH | = | Hydrated lime, magnesian |
| CL | = | Limestone, high-calcium |
| DL | = | Limestone, dolomitic |
| ML | = | Limestone, magnesian |
1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.3 The buyer shall designate the use, as listed in Table 1, and may specify one or more of the type designations listed below Table 1.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.