ASTM D0732-24
Standard Test Method for Shear Strength of Plastics by Punch Tool
| Označení normy: | ASTM D0732-24 |
| Vydáno: | 01.08.2024 |
| Status: | Active |
| Počet stran: | 4 |
| Sekce: | 08.01 |
| Označení: | punch tool; shear strength; |
| ASTM označení: | ASTM D732 |
| Nahrazuje: | D0732-17 |
1.1 This test method covers the procedure for determining the shear strength of plastics in the form of sheets, plates, and molded shapes in thicknesses from 1.27 to 12.7 mm (0.050 to 0.500 in.).
1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
Note 1: There is no known ISO equivalent to this standard.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.