ASTM D1039-16R22
Standard Test Methods for Glass-Bonded Mica Used as Electrical Insulation
| Označení normy: | ASTM D1039-16R22 |
| Vydáno: | 01.05.2022 |
| Status: | Active |
| Počet stran: | 7 |
| Sekce: | 10.01 |
| Označení: | arc resistance; compressive strength; dielectric strength; dilatometry; dissipation factor; glass-bonded mica; heat distortion; impact resistance; interferometry; linear thermal expansion; mica; modulus of rupture; permittivity; porosity; resistivity; Rockwell hardness; specific gravity; synthetic mica; tensile strength; thermal conductivity ; |
| ASTM označení: | ASTM D1039 |
| Nahrazuje: | D1039-16 |
1.1 These test methods cover the evaluation of the characteristics of glass-bonded, natural, or synthetic mica materials intended for use as electrical insulation.
1.2 Glass bonded mica materials are commercially available in both injection molded and compression molded types. These test methods are applicable to both types except for tensile strength methods. (See Section 41.)
1.3 The test methods appear in the following sections:
| Test Method | Section | ASTM Test Method |
| Arc Resistance | 57 – 59 | D495 |
| Compressive Strength | 33 – 35 | D695 |
| Conditioning | 5 | D618 |
| Dielectric Strength | 48 – 51 | D149 |
| Dissipation Factor | 43 – 47 | D150 and D2149 |
| Heat Distortion Temperature | 24 – 29 | D648 |
| Impact Resistance | 36 – 39 | D256 |
| Modulus of Rupture | 30 – 32 | D790 and C674 |
| Permittivity | 43 – 47 | D150 and D2149 |
| Porosity | 13 – 16 | D116 |
| Resistivity, Volume and Surface | 52 – 56 | D257 |
| Rockwell Hardness | 10 – 12 | D785 |
| Specific Gravity | 6 – 9 | D792 |
| Specimens | 4 |
|
| Tensile Strength | 40 – 42 | D638 and D651 |
| Terminology | 3 | D1711 |
| Thermal Conductivity | 17 – 19 | C177 and E1225 |
| Thermal Expansion | 20 – 23 | E228 and E289 |
| Thickness | 49 and 54 | D374 |
1.4 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. See also Sections 45, 49, 54, and 58.
1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.