ASTM D2063_D2063M-24
Standard Test Methods for Measurement of Torque Retention for Packages with Continuous Thread Closures Using Non-Automated (Manual) Torque Testing Equipment
| Označení normy: | ASTM D2063_D2063M-24 |
| Vydáno: | 01.05.2024 |
| Status: | Active |
| Počet stran: | 4 |
| Sekce: | 15.10 |
| Označení: | continuous thread closure; removal torque; retention ; |
| ASTM označení: | ASTM D2063/D2063M |
| Nahrazuje: | D2063_D2063M-10R18 |
1.1 This is a quantitative method that measures removal torque of continuous thread closures on containers, with matching finishes for predetermined environmental conditions over time. The range of values that can be measured are limited to the equipment used.
1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
Note 1: The SI unit system is the recommended system.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.