ASTM D2670-25
Standard Test Method for Measuring Wear Properties of Fluid Lubricants (Falex Pin and Vee Block Method)
| Označení normy: | ASTM D2670-25 |
| Vydáno: | 01.12.2025 |
| Status: | Active |
| Počet stran: | 8 |
| Sekce: | 05.01 |
| Označení: | pin and vee; tooth count; wear ; |
| ASTM označení: | ASTM D2670 |
| Nahrazuje: | D2670-20 |
1.1 This test method covers a procedure for making a preliminary evaluation of the wear properties of fluid lubricants by means of the Falex Pin and Vee Block Lubricant Test Machine.
Note 1: Certain fluid lubricants may require different test parameters depending upon their performance characteristics.
1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.