ASTM D3170_D3170M-14R22
Standard Test Method for Chipping Resistance of Coatings
| Označení normy: | ASTM D3170_D3170M-14R22 |
| Vydáno: | 01.07.2022 |
| Status: | Active |
| Počet stran: | 7 |
| Sekce: | 06.02 |
| Označení: | chipping resistance; gravelometer; |
| ASTM označení: | ASTM D3170/D3170M |
| Nahrazuje: | D3170_D3170M-14 |
1.1 This test method covers the determination of the resistance of coatings to chipping damage by stones or other flying objects.
Note 1: This test method is similar to SAE J-400.
1.2 All dimensions are nominal unless otherwise specified.
1.3 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system are not necessarily exact equivalents; therefore, to ensure conformance with the standard, each system shall be used independently of the other, and values from the two systems shall not be combined.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.