ASTM D4400-18R25
Standard Test Method for Sag Resistance of Paints Using a Multinotch Applicator
| Označení normy: | ASTM D4400-18R25 |
| Vydáno: | 01.08.2025 |
| Status: | Active |
| Počet stran: | 4 |
| Sekce: | 06.02 |
| Označení: | Anti-Sag Index; rheological properties; sag-resistance; |
| ASTM označení: | ASTM D4400 |
| Nahrazuje: | D4400-18 |
1.1 This test method covers the laboratory determination of the sag resistance of aqueous and nonaqueous liquid coatings at any level of sag resistance.
1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system are not necessarily exact equivalents; therefore, to ensure conformance with the standard, each system shall be used independently of the other, and values from the two systems shall not be combined.
Note 1: Because the only manufacturer of the applicator know to the committee manufactures to inch-pound units, inch-pound units will be regarded as the standard when referring to the applicator.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.