ASTM D6040-18R23
Standard Guide to Standard Test Methods for Unsintered Polytetrafluoroethylene (PTFE) Extruded Film or Tape
| Označení normy: | ASTM D6040-18R23 |
| Vydáno: | 01.11.2023 |
| Status: | Active |
| Počet stran: | 3 |
| Sekce: | 08.03 |
| Označení: | dielectric breakdown voltage; dielectric constant; elongation; lubricated PTFE; paste extruded PTFE; PTFE; specific gravity; tensile properties; unsintered PTFE; virgin; volatiles; volume resistivity; |
| ASTM označení: | ASTM D6040 |
| Nahrazuje: | D6040-18 |
1.1 This guide identifies test methods to use in evaluating unsintered extruded films or tapes manufactured from polytetrafluoroethylene.
1.2 The values stated in SI units as detailed in IEEE/ASTM SI 10, are to be regarded as standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
Note 1: This test method is equivalent to ISO 12086-2:2006 in the measurement of tensile properties, specific gravity, and dielectric constant. These are in ISO 12086-2:2006, sections 8.2.2, 10.6 and 8.1.1. It is not equivalent to ISO 12086-2:2006 in any other measurement or section..
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.