ASTM D8639_D8639M-26

1.1 This test method covers the procedures for conditioning asphalt mixtures in fuel and measuring their resistance to fuel degradation. The method describes the determination of fuel-induced mass loss (FML) using cylindrical laboratory-compacted asphalt mixture specimens. Fuel-conditioned mixtures may be further evaluated for mechanical properties; the measurement of fuel-induced tensile strength ratio (TSR_f) and Cantabro mass loss (CML) are described in Appendix X1 and Appendix X2, respectively.

1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with the standard.

1.3 The text of this standard references notes and footnotes which provide explanatory material. These notes and footnotes (excluding those used in tables and figures) shall not be considered requirements of the standard.

1.4 Since a complete precision and bias statement for this standard has not been developed, the test method is to be used for research and informational purposes only. Therefore, this standard should not be used for acceptance or rejection of a material for purchasing purposes.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.